Understanding Electronic Components: All components are illustrated and the circuit-symbol is explained in detail. Both simple and complex examples are provided for the beginners. These include resistors, capacitors, transformers, transistors, integrated circuits, etc and each has its own symbol to represent it in an electrical or electronic diagram - called a circuit diagram.

Date Added: 8/3/2011 12:48:03 AM | Visits: 31671

Radio Receivers, from crystal set to stereo: It is hard to imagine what would the modern world look like without the permanent exchange of huge quantity of information. It is being transferred by various means (newspapers, telephone, the Internet etc.), however, the fastest way of doing it, and sometimes the only one, is by radio, where transfer is being done by electromagnetic waves, traveling at the speed of light.

Date Added: 8/3/2011 12:39:28 AM | Visits: 34010

RF Basic 1: Notes on RF Basic.

Date Added: 8/3/2011 12:38:15 AM | Visits: 31796

RF Basics: � Building blocks in RF system and basic performances
� Device characteristics in RF application
� Low noise amplifier design
� Mixer design
� Oscillator design

Date Added: 8/3/2011 12:31:44 AM | Visits: 32630

dBm volts watts conversion table: Table of dBm volts watts conversion.

Date Added: 8/3/2011 12:29:38 AM | Visits: 33145

Smith chart tutorial3: For lower frequency circuits, lumped elements are normally used instead of transmission lines.

Date Added: 8/3/2011 12:28:41 AM | Visits: 34020

Smith chart tutorial2:
For lower frequency circuits, lumped elements are normally used instead of transmission lines.

Date Added: 8/3/2011 12:20:19 AM | Visits: 33624

Smith chart tutorial1: For lower frequency circuits, lumped elements are normally used instead of transmission lines.

Date Added: 8/3/2011 12:17:08 AM | Visits: 34423

Basic Equipment Design Tutorial: For any given piece of RF/Microwave hardware there
has to be a specification, which defines the electrical,
mechanical and environmental performance of the
equipment

Date Added: 8/3/2011 12:04:00 AM | Visits: 33101

Specifications and Measurement of Local Oscillator Noise in Integrated Circuit Base Station Mixers: Residual phase noise from local oscillators (LO) can be degraded by additive noise of on-chip local
oscillator drivers/buffers in integrated circuit mixers. Reciprocal mixing of strong RF signals with the LO noise degrades the receiver sensitivity.

Date Added: 8/3/2011 12:02:52 AM | Visits: 31894